CUSTOMLIGHTSABER.COM - Whois Information
Custom Lightsaber
In order to make the custom lightsaber, high skills and technical knowledge is required. It is not easy to make these equipments. One of the best ways to light up the blades of custom lightsabers was to use something with a bright light source. This was so because using electroluminescence was costly. It cost good sum to use electroluminescence as a light source. Keeping the cost in mind, it was seldom use. Other alternate was EL. It was not so expensive but it was ordered from international markets, so it took time to bring it to the desired place. It also needed protection of its lighting strip. It could be done with tough polycarbonate tubes.
Customlightsaber.com
To improve performance of WHOIS service and to prevent its excessive high-volume use by a single source, we implemented a randomly generated Access Code that must be entered before running a WHOIS request.
The Access Code in the box is provided in graphics format. It has letters which are generated randomly and the symbol images are distorted. The distorted symbols cannot be read by computer programs which are used for mass-collect email addresses and any customer information. Only humans can read the distorted symbols and pass the access code.
The Access Code improves performance of our services. It prevents excessive high-volume use by a single source.
The services that require Access Codes are:
Whois – after entering the correct Access Code you can run 10 WHOIS requests before you will be prompted to enter a new Access Code.
Site Info – you can run 25 Site Info requests before you will be prompted to enter an Access Code.
Trace Route - you can run 20 Trace Route requests before you will be prompted to enter an Access Code.
RBL Check - you can run 20 RBL Check requests before you will be prompted to enter an Access Code.
What’s my IP - Access Code is not required for this service.
NOTE: We may modify Access Code policy at any time without notice on this web page.
