LIGHTSPEEDBATTERIES.COM - Whois Information
Lightspeed Batteries - West Wales Models
Design.
Lightspeed cells use only the highest quality components coupled with some very special chemicals in their construction.
One example of this, is the use of "Lithium Titanate" on the "Anode" rather than the normal "Carbon Anode". The Lithium Titanate electrode drastically reduces damage from charging and furthermore substantially reduces the risk of cell expansion and membrane rupture.
In addition not only can the charge times be reduced, but the lifespan of the battery is hugely increased above and beyond that of a conventional Lithium Polymer battery.
Are they any disadvantages associated with the use of Titanate within the cell ?
The only disadvantages associated with Lithium Titanate cells are:-
The cells are quite a bit more expensive to produce. A standard Lithium Titanate cell has a slightly lower voltage than a standard Lithium Polymer cell, however the use of some rather "exotic" chemicals within the cell now allow our cells to operate at a nominal voltage of 3.71V. The maximum operational voltage of the cell is 4.22V, this makes the cell voltage comparable with a standard Lithium Polymer battery and allows the battery to be charged on a standard Lithium-Polymer charger. Construction.
Individual cells are connected together using ultra low resistance materials, with the main output cabling being constructed exclusively from silicon coated OFC (Oxygen Free Copper), High quality gold plated "Deans" covered in "Glued" heatshrink are used to terminate all Lightspeed Batteries.
The very low internal resistance of Lightspeed Batteries (typically 8 – 10 milliohms) give huge benefits such as:-
Far longer battery lifetimes with upwards of 1000 cycles expected for a battery pack. Lower heat build-up during the discharge cycle. Faster cell recovery. Lower voltage drop under loads, which equates directly to a much higher RPM per volt from your electric motor. More available power for the battery pack. Ability to charge at higher charge rates (It is important to allow the battery to cool below 25c before charging commences). Suitable for all applications and especially so for use in high current applications.
Lightspeedbatteries.com
To improve performance of WHOIS service and to prevent its excessive high-volume use by a single source, we implemented a randomly generated Access Code that must be entered before running a WHOIS request.
The Access Code in the box is provided in graphics format. It has letters which are generated randomly and the symbol images are distorted. The distorted symbols cannot be read by computer programs which are used for mass-collect email addresses and any customer information. Only humans can read the distorted symbols and pass the access code.
The Access Code improves performance of our services. It prevents excessive high-volume use by a single source.
The services that require Access Codes are:
Whois – after entering the correct Access Code you can run 10 WHOIS requests before you will be prompted to enter a new Access Code.
Site Info – you can run 25 Site Info requests before you will be prompted to enter an Access Code.
Trace Route - you can run 20 Trace Route requests before you will be prompted to enter an Access Code.
RBL Check - you can run 20 RBL Check requests before you will be prompted to enter an Access Code.
What’s my IP - Access Code is not required for this service.
NOTE: We may modify Access Code policy at any time without notice on this web page.
