MOLDADVISOR.COM - Whois Information
Trask Research Mold Treatment and Healthcare Products
Mold Killer :: ImpactT is a concentrated EPA registered mold killer concentrate which disinfects, prevents, and kills all mold and mold spores on materials subject to fungal contamination. Click here to see what the EPA has to say about Mold in your home. The fungicide is sprayed wet onto moldy surfaces and moldy building materials. ImpactT kills ALL mold species, including the deadly toxic black mold Stachybotrys or Black Mold, Aspergillus, Penicillium, and other toxic molds. Like all fungicides, ImpactT can only kill mold spores and mold colony growths with which it comes into actual contact with. 1 gallon of concentrate makes up to 65 gallons of mold killer [2 ounces of ImpactT per gallon of water] for $99.95. It is also available in 5 gallon pails for $449.95. Spray diluted ImpactT with a commercial fogger, small hand-held sprayer, electric sprayer, or with a hand-pumped sprayer. Each diluted gallon [65 diluted gallons can be made from each gallon of ImpactT] will spray one wet coating on 100 square feet. You should spray a minimum of two wet coatings of ImpactT onto the treatment area [with natural drying in between spraying]. ImpactT is a very safe and effective fungicide mold killer when applied properly in your home or building via spraying or fogging, if used inside heating and cooling ducts and equipment, inside the home or office must be vacated and system allowed to dry thoroughly before reinhabiting the area. This also applies to application inside the home. What is fogging? Fogging is the fastest way to apply mold treating products to a large area. Fogging is a way to atomize (minute mist) the chemical application of the product so that it may be delivered to every part of the targeted area extremely effectively. Attics, crawl spaces, large rooms or areas, and new construction are ideal for fogging. Pump spraying may also be an option depending on the application.
Moldadvisor.com
To improve performance of WHOIS service and to prevent its excessive high-volume use by a single source, we implemented a randomly generated Access Code that must be entered before running a WHOIS request.
The Access Code in the box is provided in graphics format. It has letters which are generated randomly and the symbol images are distorted. The distorted symbols cannot be read by computer programs which are used for mass-collect email addresses and any customer information. Only humans can read the distorted symbols and pass the access code.
The Access Code improves performance of our services. It prevents excessive high-volume use by a single source.
The services that require Access Codes are:
Whois – after entering the correct Access Code you can run 10 WHOIS requests before you will be prompted to enter a new Access Code.
Site Info – you can run 25 Site Info requests before you will be prompted to enter an Access Code.
Trace Route - you can run 20 Trace Route requests before you will be prompted to enter an Access Code.
RBL Check - you can run 20 RBL Check requests before you will be prompted to enter an Access Code.
What’s my IP - Access Code is not required for this service.
NOTE: We may modify Access Code policy at any time without notice on this web page.
